2023 BREHMER 24 FT (150098629686)

Description

New Trailer Tender in Stock
All Trailers have the front of the Rear Fender Section made from 304 Stainless
All Trailers have the Option to have a 304 Stainless Top Deck and Rear Fenders
All Lights are LED
Tender Box of Constructed out of 304 Stainless Steel with LOW center of gravity Box
Bins are Shorter than competitors Box
Provides better product flow for less cleanout needs than others
Bins Allow for less Product Travel in the Corner of Sheets
Units Hold Same if Not More Capacity than Competitors Box o Pull Handles {E-Z Handles) a 4-to-l Ratio
Allows for smooth and easy opening and closing of gates o Reinforced Top Lip 12 Ga 304 Stainless Steel Construction o Rocker Plate installed on 24′ Tender Boxes
Allows for the box to flex and not damage when taking corners
Stainless Coupler Cleanouts installed all boxes o Grease Banks are made from Specialized Crimp Fittings
This allows for the service department to use Pneumatic Grease Guns, Saves Time and makes the service more convenient
Auger System is Utilizing a 304 Stainless Steel Coupler on All Ends .This is for removing bearings and longevity of the parts
Saves time from battling to get the Bearing Components Off o ALL Augers DO NOT use a hanger bearing
Saves the hassle from maintenance and greasing Ultimately Less Downtime o Vertical Bearing has a notch and a custom slinger plate Installed
Allows product to exit the bearing without building, Allows moisture and water to escape the bearing o Side Discharge Auger Utilizes a Brass Bushing and Custom Locking Cylinder
The cylinder mounted to give a pulling effect the discharge tube, allowing the gap between the small discharge auger and the large tube to shut without the need to lock or throw- any other devices this way our Orbit Motors use a pushing rather than Pulling effect the augers
Char-Lynn Motors utilize High Torque Curve to maintain ratings specified by Brehmer
Augers rotate around 535RPM compared to the average 300RPM of competitors o System Pressure will stay between 2700-3000 PSI to maintain discharge rates, around 4000 lbs/min
Deltron EN30s Needle Valve allows for control of the belly auger to adjust the system pressure effectively, Allowing Gates to be entirely open for product flow without the concern of backing up and plugging the auger system.
Brehmer Mfg. utilizes specific hardware to test stainless steel to ensure product 100% 304 Stainless Steel.